Steddi Go PCB Set

This is a PCB set for building your own Steddi Go preamp/D.I. This is not a beginner project, so if you’ve never built a pedal before, then this isn’t for you.

I’ve tried to make this as affordable and as easy to assemble as possible, but this is a high-voltage circuit and requires special care in assembly, testing, and use. Conspiracy to Commit Electronics is not responsible for any damage or injury caused by improper handling, assembly, or use of this circuit.

Steddi Go is a clean tube preamp/D.I. for guitar and bass. It was designed to be as simple as possible, with only a volume control. It has an additional switch on the face to allow the 1/4″ output to act as a dry-pass through or as an additional preamp output.

Each PCB also includes a “12AX7-LEFT” PCB for mounting the tube socket and a D.I./XLR PCB for mounting the XLR jack, ground lift switch, and D.I. transformer. The optional transformer is the Unagi E4305, the same transformer used in the Sushi Box FX Finally v3, Venus Z, Neptunium, and Grand Slampegg. A pre-drilled enclosure can be purchased from Tayda Electronics, instructions to come.

You can find the build document with the BOM, schematics, and enclosure drill guide can be found here.